Agilent N518xA, E8663B, E44x8C, and E82x7D Signal Generators Programming Guide 279
6 Creating and Downloading User-Data Files
NOTE Some features apply to only the E4438C with Option 001, 002, 601, or 602 and E8267D with
Option 601 or 602. These exceptions are indicated in the sections.
On the Agilent MXG, the internal baseband generator speed upgrade Options 670, 671, and
672 are option upgrades that require Option 651 and 652 to have been loaded at the factory
(refer to the Data Sheet for more information). Any references to 651, 652, or 654 are
inclusive of 671, 672, and 674.
The following sections and procedures contain remote SCPI commands. For front panel key
commands, refer to the User’s Guide, Key and Data Field Reference (ESG, PSG, and
E8663B), or to the Key Help in the signal generator.
This chapter explains the requirements and processes for creating and downloading user- data, and
contains the following sections:
• “User File Data (Bit/Binary) Downloads (E4438C and E8267D)” on page 286
• “Pattern RAM (PRAM) Data Downloads (E4438C and E8267D)” on page 309
• “FIR Filter Coefficient Downloads (N5182A, E4438C and E8267D)” on page 322
• “Save and Recall Instrument State Files” on page 325
• “User Flatness Correction Downloads Using C++ and VISA” on page 336
• “Data Transfer Troubleshooting (N5182A, E4438C and E8267D Only)” on page 340
To Next Page
Loading...
Need help?
General
