EasyManua.ls Logo

Agilent Technologies EasyEXPERT

Agilent Technologies EasyEXPERT
610 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5 MCSMU_IV
5.3 Id-Vgs MCSMU 2-stage: Id-Vgs characteristics, MCSMU Pulse
(A.05.50_2013.04.10.1)
[Supported Analyzer]
B1500A
[Description]
Measures Drain current vs Gate voltage characteristics. SMU pulses are used for the Drain-Source and gate-
Source voltage output.
Measurement is performed twice with lower compliance for low current region, higer compliance for high
current region, then merge two curves.
[Device Under Test]
Power MOSFET, 3 terminals and Subs terminal
[Device Parameters]
Polarity: Nch (SMUs force the specified value) or Pch (SMUs force the negative specified value).
Temp: Temperature
YAxisgfsMin: Y axis (gfs) minimum value
YAxisgfsMax: Y axis (gfs) maximum value
[Test Parameters]
Memo: Memo
Gate: SMU connected to gate terminal, primary sweep voltage output
VgStart: Sweep start voltage for gate terminal
VgStop: Sweep stop voltage for gate terminal
VgStep: Sweep step voltage for gate terminal
GatePulseWidth: Gate pulse width
GateDelay: Gate pulse delay (Effective only for MCSMU)
GatePulseWidth2: Gate pulse width for lower current measurement
GateDelay2: Gate Pulse delay for lower current measurement (Effective only for MCSMU)
Source: COMMON connected to source terminal, 0 V voltage output
Drain: SMU connected to drain terminal, secondary sweep voltage output
VdStart: Sweep start voltage for drain terminal
VdStop: Sweep stop voltage for drain terminal
VdPoint: Sweep step point for drain terminal
IdLimit: Drain current compliance
DrainPulseWidth: Drain pulse width
IdLimit2: Drain current compliance for lower current measurement
DrainPulseWidth2:Drain pulse width for lower current measurement
EnableSubs: Enable or Disable Subs terminal assignment
Subs: SMU connected to Subs terminal, constant voltage output
Vsubs: Constant voltage for Subs terminal
PulsePeriodMode: Pulse period mode (AUTO or MANUAL)
ManualPulsePeriod: Manual pulse period
MeasurementTime: Measurement time
MeasurementTime2:Measurement time for lower current measurement
Agilent EasyEXPERT Application Library Reference, Edition 8
5-7

Related product manuals