17 Utility
17.3 ForcePG2P: PG Output1/Output2 (A.01.20)
[Supported Analyzer]
B1500A, B1505A, 4155B, 4155C, 4156B, 4156C
[Description]
Sets Output1 and Output2 of Agilent 81110A Pulse Generator, and triggers it. Pulse leading/trailing edge
transition time can be set.
Execute ResetPG to stop pulse output before the specified pulses are applied.
[Required Modules and Accessories]
Agilent 81110A Pulse Generator (2-output, PGU1 and PGU2)
GPIB cable
[Test Parameters]
Address: GPIB address of Agilent 81110A Pulse Generator
Period1: Pulse period [s] for port 1
Delay1: Pulse delay time [s] for port 1
Width1: Pulse width [s] for port 1
LeadTime1: Pulse leading edge transition time [s] for port 1
TrailTime1: Pulse trailing edge transition time [s] for port 1
Level1: Pulse High level [V] for port 1
Base1: Pulse Low level [V] for port 1
ExtImp1: Load impedance [ohm] for port 1
Period2: Pulse period [s] for port 2
Delay2: Pulse delay time [s] for port 2
Width2: Pulse width [s] for port 2
LeadTime2: Pulse leading edge transition time [s] for port 2
TrailTime2: Pulse trailing edge transition time [s] for port 2
Level2: Pulse High level [V] for port 2
Base2: Pulse Low level [V] for port 2
ExtImp2: Load impedance [ohm] for port 2
NoOfPulse12: Number of output pulses
Agilent EasyEXPERT Application Library Reference, Edition 8
17-5