8
BATTERIES
Make sure the control knob is in the "OFF" position. Unscrew the
push button cap on the ignition module located on the control
panel to access the battery compartment. The ignition module
requires one Duracell® AA size battery (1.5V). The negative (-)
end goes in first. See Figure 7. Dispose of battery safely. Battery
may explode or leak if charged or disposed of in fire. Make sure of
the polarity. The battery included is mercury and cadmium free.
CAUTIONS: BATTERY INSTRUCTIONS
●Always purchase the correct size and grade of battery most suitable for the intended use.
●Always replace the whole set of batteries at one time, taking care not to mix old and new ones, or batteries of
different types.
●Clean the battery contacts and also those of the device prior to battery installation.
●Ensure the batteries are installed correctly with regard to polarity (+ and -).
●Remove batteries from equipment which is not to be used for an extended period of time.
●Remove used batteries promptly.
For recycling and disposal of batteries to protect the environment, please check the internet or your local phone
directory for local recycling centers and / or follow local government regulations.
MAINTENANCE
The flames should look like those in Figure 8. To clean the burner, use a soft brush after the
burner has cooled completely. Never use a vacuum cleaner on the burner. It is
recommended to store the firepit indoors during winter if it will be subjected to freezing
temperatures. The LP cylinder must be disconnected and removed from the appliance
before the appliance can be stored indoors.
Figure 7
Figure 8
To Next Page
Loading...
