How to fix pickup skipping swath on AgLand Farm Equipment?
To address a pickup that is skipping swath or not picking cleanly on your AgLand Farm Equipment, you might need to replace missing teeth, adjust the pickup height, use a lower tractor gear with higher RPM, or follow the same direction as the swath cut.
What to do if material is wrapping in pickup of AgLand Farm Equipment?
If you're experiencing material wrapping in the pickup of your AgLand Farm Equipment, consider replacing any missing or worn nylon plates. Additionally, try to match the pickup and ground speed as closely as possible.
What to do if hay is not being macerated by AgLand Farm Equipment?
If the hay is not being macerated by your AgLand Farm Equipment, you can adjust the air pressure as required, narrow the gap between the steel rolls, cut wider or thinner windrows, or increase the tractor RPM.
Why is there excessive noise from the gearbox of AgLand Farm Equipment?
If you notice excessive noise or heat from the gear box of your AgLand Farm Equipment, top up the gear oil as needed or replace parts as needed.
How to prevent breakage of pickup teeth on AgLand Farm Equipment?
If you're experiencing breakage or bending of the pickup teeth on your AgLand Farm Equipment, adjust the pickup height or reduce the pickup or ground speed.
What to do if air pressure does not hold in air tank of AgLand Farm Equipment?
If the air pressure isn't holding in the air tank and air bags of your AgLand Farm Equipment, repair or replace the line as needed, replace the air bag as needed, or clean or replace the regulator.
What to do if pickup does not rise on AgLand Farm Equipment?
If the pickup on your AgLand Farm Equipment does not rise or lower, replace the hydraulic lines and cylinders as needed, or replace or clean the bushings.
How to fix rubber rolls not feeding properly on AgLand Farm Equipment?
If the rubber rolls on your AgLand Farm Equipment aren't feeding properly, adjust the air pressure using the regulator or adjust the gap width.
How to fix pickup height adjustment that does not hold on AgLand Farm Equipment?
To address the issue of the pickup height adjustment not holding on your AgLand Farm Equipment, replace worn parts as needed.
How to prevent excessive leaf loss with AgLand Farm Equipment?
To minimize excessive leaf loss with your AgLand Farm Equipment, release air pressure, condition hay early in the morning, or adjust the gap between the steel rolls.
Explains DANGER, WARNING, CAUTION signal words and general safety alerts.
Covers transport, operating, hydraulic, and air system safety procedures.
Detailed steps for replacing worn or damaged drive belts.
Instructions for replacing sealed ball bearings and locking collars.
Procedures for checking and replacing pickup teeth, wrappers, and wear strips.
General| Brand | AgLand |
|---|---|
| Model | MACERATOR 6610 |
| Category | Farm Equipment |
| Language | English |
To Next Page