Installing the battery
You must install and charge the battery to use your phone.
Insert the ridge at the top of the battery into the base of the
phone, make sure to touch the metal contact on the phone,
then push the battery down and snap it into place.
Note:
Your phone is designed to be used only with original batteries
and chargers. Use of other batteries or chargers may cause
damage to your phone and the warranty will be void.
Removing the battery
Make sure your phone is powered off to avoid the important
information getting lost.
Hold battery bottom and remove the battery from the phone.
Charging the battery
New batteries are shipped partially charged. Before you can
use your phone, you need to charge the battery. Some
batteries will have best performance after several full
charge/discharge cycles.
1. Connect data cable and charger, plug one end into your
phone’s data port.
2. Plug the other end of the charger into the appropriate
electrical outlet (100~240V AC).
3. When your phone indicates that the battery is fully
charged, remove the charger.
Notes:
To Next Page
Loading...