9
11
10
12
9
Carefully lift the upper deck away from the lower deck so that you can fit
the driver’s door in place. As you fit the door, ensure that the pegs on the
bottom of the inner door panel 93D fit into the slot in the cabin floor 35A
(inset above). Lower the upper deck in place, ensuring that the pegs on the top
of the inner door panel 93D fit into the groove in the cab ceiling 76A.
11
Fix the front framework 80F to the right wall
framework 87A, the left wall framework 85A and
the cab frame 40A using three FM screws.
10
Check that the door is properly fitted and
able to slide open and closed. Fix the right
wall framework 87A to the cab frame 40A with
an FM screw.
12
Take the front (blind) frame 80H (supplied with
stage 80) and fit it against the front frame 80F.
Check that the screw holes are aligned, and fix in place with
eight KM (red) screws.
FM
FM
x3
93D
93D
35A
87A
40A
76A
93D
35A
76A
85A
40A
80F
87A
80H
80F
KM
x4
KM
x4
16
16
AGORAMODELS ROUTEMASTER BUS
17
AGORAMODELS ROUTEMASTER BUS
To Next Page
Loading...
