You may find that there is not enough space for the bell pull mechanism to move before the knot
tying the cord to the control slider touches the ceiling framework. Consequently, if the knot is too
large, it will restrict the bell pull mechanism’s function. To resolve this problem, please try re-tying
the cord to a the section of the control slider 55I shown by the red arrow in the image below.
Alternatively, you can also file a notch in the crossbar of ceiling framework 70A in the position
shown by the red arrow in the image below to allow the knot to pass through.
EXPERT ADVICE: EXPERT ADVICE:
BELL PULL MECHANISMBELL PULL MECHANISM
55I
70A
2
2
AGORAMODELS ROUTEMASTER BUS
PB
AGORAMODELS ROUTEMASTER BUS
To Next Page
Loading...
