4
1
2
3
1
Take the right wall framework
95A and the window pane 95G.
Fix the window pane to the inside of
the framework, over the wheel arch,
using four EM screws.
2
As in previous stages, remove the excess moulding
from the manufacturing process on the sliding
window pane 95E and the window frame 95D.
3
Fit the sliding window pane 95E into the window
frame 95D so that ridges on the ends of part 95E fit
into the grooves in the frame 95D. The ‘metal’ edge goes
at the top.
4
Fit the window frame 95D on
to the outside of the right wall
framework 95A. Fix in place from
the inside with two BP screws.
95E
BP
BP
95E
95D
95D
95D
95A
95A
95G
EM
x4
24
24
AGORAMODELS ROUTEMASTER BUS
25
AGORAMODELS ROUTEMASTER BUS
To Next Page
Loading...
