Agora Models RM 857 - Page 30

11
12
11
Note where the cable comes
through to the back of the rear
seat (circled). Continue re-routing cable
72A from the middle of the back of the
seat down over the structure behind the
seat to the top of the rear lower deck
ceiling panel 54A, as shown.
12
Refit the rear wall panel 81A. As you do so, guide
the cable 72A through the notch in part 81A, as
indicated by the light blue dotted line. Fix the rear panel
81A in place with two JP screws in the rear and two at the
back right side (fixing to part 79C). Finally, replace the two
JP screws at the back left side (fixing to part 78C, inset).
10
After removing the two JP screws
holding the back wall panel 81A
to the rear seat back panel 66A, remove
the back wall panel, as shown. Guide the
cable 72A into the crevice between the
rear wall 74A and the rear seat back panel
66A. Ease the cable down into the crevice
as indicated by the light blue arrow.
10
81A
74A
72A
66A
66A
72A
54A
74A
79C
81A
66A
72A
72A
54A
78C
JP
x2
JP
x2
JP
x2
JP
x2
30
30
AGORAMODELS ROUTEMASTER BUS
31
AGORAMODELS ROUTEMASTER BUS