agratronix MT-PRO - English; Default Chapter; Table of Contents

Contents
ii
Page
Operation
Operating Conditions
........................................................................05-1
Operational Messages .....................................................................05-1
Moisture Limit Guidelines .................................................................05-2
Operating Procedure - Preheating ...................................................05-3
Operating Procedure – Normal Operation ........................................05-4
Average Test Results ........................................................................05-5
Select a New Grain Scale or Function .............................................05-6
Select a Different Language .............................................................05-6
Calibration Modes ............................................................................05-7
Select a Different Calibration Mode ..................................................05-8
Calibration Consideration / Limits .....................................................05-8
Adjust Calibration – Simple Option ...................................................05-10
Adjust Calibration – Advanced Option ..............................................05-11
Clear Calibration – Simple Option ....................................................05-12
Clear Calibration – Advanced Option ...............................................05-12
Display Temperature in the Cell ........................................................05-13
Turn on Backlight and Turn off Tester ...............................................05-13
Troubleshooting .............................................................................10-1
Service
Check Battery Power Levels and Replace Batteries ........................15-1
Clean the Tester ...............................................................................15-1
Warranty
Warranty ...........................................................................................20-1
Record Serial Numbers ....................................................................20-1
Manufacturer’ Contact Information
Manufacturer’s Contact Information .................................................25-1
Accessories ......................................................................................25-1
All information, illustrations and specifications in this manual are based
on the latest information available at the time of publication. The right is
reserved to make changes at any time without notice.