STOPPING INSTRUCTIONS
SERVICE AND MAINTENANCE
BE-WC42G
PTO MODEL
• Move tractor throttle to low idle.
• Disengage tractor PTO and stop engine.
• Remove key to avoid engine startup.
WARNING!
Make sure machine has come to a complete stop before
disconnecting PTO or attempting to adjust or repair chipper.
The chipper rotor may continue to rotate even with the engine stopped
Never lift hopper before machine has come to a complete stop.
Sharpening Knives:
It is recommended that you sharpen the chipper knives as required. Knives may need sharpening more or
less frequently, varying on type of wood chipped. Knives will need to be set up to stationary knife after
each sharpening. Knives are reversible and can be reversed between sharpening.
To sharpen Knife:
1. Check to make sure rotor has come to a complete stop and power source is shut o.
2. Open rotor housing by loosening access cover clamp.
3. Rotate rotor by hand to access knives. Caution must be used while turning rotor;
even slow rotation could cut or sever a hand or fingers.
45°
To Next Page
Loading...