AgSense Crop Link Pro - Wiring 120 v AC Power

Wiring 120v AC Power to the Crop Link Unit
If you are not using DC power or Solar Power: how to wire 120v AC to the Crop Link.
1. Connect 120v AC to the terminal marked 120v – units pre-wired with a cable from
AgSense use a Black wire. Cable added by the customer should use the Black wire
here.
2. Connect the Neutral wire to the terminal marked N. – units pre-wired with cables
from AgSense use either a Brown/Black Stripe or a White wire. Cable added by the
customer should use the white wire.
Page 3