STERILIZATION MODE
1
Fill the container with water, not exceeding the mark «MAX» (280 ml) on
the left side of the device.
2
Install the blender bowl, and then insert the steaming basket (9) into the
bowl.
3
Put the bottle in the steaming basket, and then cover it with the measur-
ing cup (7).
4
Activate the sterilizer mode by pressing the button . The default time
for this mode is 8 minutes. You can press the buttons
to increase
or decrease the sterilization time from 1 minute to 30 minutes.
Then press
to start the device. If you want to suspend the device during
operation, press this button again.
After completing the sterilization, the device will beep 6 times.
5
Remove the measuring cup and take out the bottle or other objects using
the tweezers (14).
HEATING MODE
1
Fill the water container*.
*Note: approximately 100 ml of water.
2
Place the blender bowl (6) on the device base, turn it, and then put the
steaming basket (9) into the bowl.
To Next Page
Loading...