Engine parameters : Check within limits.
External power : Disconnect (if used). Check
BATT OFF caution message
out (only for helicopters
equipped with emergency bus).
INV 1 and 2 switches : ON.
RAD- MSTR switch : ON.
Clock : Set.
Rotor speed (NR) : 100% check.
QUICK ENGINE START
This procedure can be followed whenever the situation requires to speed up the
takeoff.
CAUTION
It is not advised to accomplish this procedure on battery.
Collective control : Flat pitch, check.
Rotor brake (if installed) :
Disengaged (lever full forward).
EDU 1 : Select START page.
ENG 1 MODE switch : FLT.
ENG 2 MODE switch : FLT, when engine 1 gas pro-
ducer (N1) is above 10%.
RFM A109E
R.A.I. Approved 2-25
Rev. 19
To Next Page
Loading...