Aico SmartLINK Ei3000MRF - Introduction

3
The Ei3000MRF SmartLINK Module is the next generation RF module designed
to fit in the Ei160e and Ei2110e series, Easi-fit mains powered Alarms. The
Ei3000MRF RadioLINK Module effectively replaces the Ei168RC RadioLINK Base.
The primary function of the Ei3000MRF is to wirelessly interconnect all Ei
Electronics Alarms in a system by the means of an RF signal i.e. when one Alarm
senses a fire event, the Ei3000MRF module attached to that Alarm will transmit an
RF signal that will activate the sounders in all other Alarms in the system.
The Ei3000MRF module is plugged into the rear of the base of an Ei160e or
Ei2110e series Alarm. RF communication through this module eliminates the
need to install long interconnect wires between all the Alarms on different floors
in different rooms. The Ei3000MRF is powered from the Alarm it is connected to.
The module also has “multiple repeater” transmission – this provides multiple signal
paths to create a robust RF ‘mesh’ system and also increase the RF range.
Introduction