24
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) this device must accept any interference received, including
interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee whether interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to remove the interference by
one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
1720
1845
1970
2450
5240
5500
5785
GSM 1800;
CDMA
1900;
GSM 1900;
DECT;
LTE Band
1, 3,4,
25; UMTS
Bluetooth,
WLAN,
802.11
b/g/n,
RFID 2450,
LTE Band 7
WLAN
802.11
a/n
1700–
1990
2400–
2570
5100–
5800
Pulse
modula-
tion
217 Hz
Pulse
modula-
tion
217 Hz
Pulse
modula-
tion
217 Hz
2 0,3 28 28
2 0,3 28 28
0,2 0,3 9 9
To Next Page
Loading...
