Aimpoint 3XMag-1 - 2 OPERATION; 2.1 Installing the Aimpoint 3 XMag-1 on a weapon

2 OPERATION
WARNING: Ensure the weapon is not loaded and the safety selector is in the
”safe” position before attempting to install, remove or perform maintenance
on the 3XMag-1 - other than attaching/detaching it under normal use.
For quick attachment/detach, we recommend the Aimpoint FlipMount or the
Aimpoint TwistMount as shown in Fig. 3.
Follow the manufacturer’s instructions when installing the 3XMag-1.
2.1 Installing the Aimpoint
®
3XMag-1 on a weapon
The mounting surface (3) of the 3XMag-1 allow for mounting to any 30 mm
diameter ring mount when the rubber cover is cut away, see Fig. 2.
i
Aimpoint
®
FlipMount
i
Aimpoint
®
TwistMount
3. Mounting surface
3
Fig. 2 Cut away rubber cover
Fig. 3 Recommended mounts