Aimpoint Acro C-2 - Turn ON;OFF and Adjust Red Dot Intensity

c Insert battery (2) with the positive end (+) toward the
battery cap (3) as seen in Fig. 1.
CAUTION: Check that the o-ring on the battery cap (3)
is in position and in good condition to ensure there is no
water leakage into the battery compartment.
d Tighten the battery cap (3) with the Aimpoint tool (8B).
When resistance is encountered, proceed to tighten
until the battery cap (3) is fully tightened.
NOTE: For long term storage of the sight, remove the
battery.
2.2 Turn ON / OFF and adjust red dot intensity
• Press or to turn the sight ON.
NOTE: The sight will always turn ON at setting 7 of 10.
• Hold to turn the sight OFF.
• Press or to adjust red dot intensity.
NOTE: Intensity setting 1-2 are intended for use with
NVD and intensity setting 3 - 10 for use in daylight.