Aimpoint Duty RDS - 2.2 Turn ON; OFF and adjust red dot intensity

c Insert battery (5) with the positive end (+) toward the
battery cap (4) as seen in Fig. 1.
CAUTION: Check that the o-ring on the battery cap (4)
is in position and in good condition to ensure there is no
water leakage into the battery compartment.
d Tighten the battery cap (4). When resistance is
encountered, proceed to tighten until the battery cap (4)
is fully tightened.
NOTE: For long term storage of the sight, remove the
battery.
2.2 Turn ON / OFF and adjust red dot intensity
• Press any of the push-buttons (1) or to turn
the sight ON.
NOTE: The sight will always turn ON at setting 7 of 10.
• Press to increase red dot intensity.
• Press to decrease red dot intensity.
• Hold to turn the sight OFF.
NOTE: Intensity setting 1 - 4 are intended for use with
NVD and intensity setting 5 - 10 for use in daylight.