U-09: Date
This screen displays the date according to the setting of initialization stage. The display format is
MM/DD/YY.
U-10: Time
This screen displays the time according to the setting of initialization stage.
U-11: Temperature
This screen displays the temperature detected in AIMS MPPT+ Battery Charger.
U-12: Battery SOC
This screen displays the State Of Charge (SOC) as a percentage of fully charged. SOC will only
be visible when terminal BVS (Battery Voltage Sensing) is connected to the battery and will only
be active when using an optional 50mv/500amp external shunt.
U-12 will only be displayed when the terminal BVS (Battery Voltage Sensing) is wired to the※
battery. To show the precise values, an optional 50mv/500amp external shunt is needed.
U-13: Battery Current
This screen displays the battery current in Amps. Battery Current will only be visible when
terminal BVS (Battery Voltage Sensing) is connected to the battery and will only be active when
using an optional 50mv/500amp external shunt.
U-13 will only be displayed when the terminal BVS (Battery Voltage Sensing) is wired to the※
battery. To show the precise values, an optional 50mv/500amp external shunt is needed.
U-14: Battery Amp Hours
This screen displays the battery capacity in AHr (Amp Hours). Battery Amp Hours will only be
visible when terminal BVS (Battery Voltage Sensing) is connected to the battery and will only be
active when using an optional 50mv/500amp external shunt.
U-14 will only be displayed when the terminal BVS (Battery Voltage Sensing) is wired to the※
battery. To show the precise values, an optional 50mv/500amp external shunt is needed.
U-15: Battery Temperature
This screen displays the battery temperature in . ℃ Battery Temperature will only be visible when
Battery Voltage Sensor is connected and will only be active when using a Battery Temperature
Sensor (BTS-3).
U-15 will only be displayed when the terminal BVS (Battery Voltage Sensing) is wired to the※
battery. To show the precise values, a Battery Temperature Sensor (BTS-3) is needed to be
wired to terminal BTS.
To Next Page
Loading...
