U-16: Parallel COMM Status
This screen displays the communication status between Master unit and Slave units. U-16 is only
displayed when Slave is selected as AIMS MPPT+ Network MODE (F-01).
When the communication is successful, the screen displays SLAVE UNIT. When the
communication fails, then screen displays NETWORK ERROR.
U-17: Serial Number
This screen displays the unit serial number. It is useful when contacting for Technical Support.
*** Main Menu***
Initialize
A-01: Access Level
Use Constant A-01 to select the user constant access level.
This level determines which user constants can be changed and displayed.
Settings:
A-01=Constant Set (Factory Setting)
This setting allows all user constants to be changed and displayed.
A-01=Operation Only
This setting allows the “Operation” and “Initialize” to be changed or displayed.
A-02: Init Parameters
Use Constant A-02 to initialize the user constants.
When initialized, the user constants will return to their factory preset values. You should normally
record the setting of any constants that are changed from factory presets.
Settings:
A-02=Preset Setting
This setting allows the user to initialize back to factory settings.
A-02=No Initialize (Factory Setting)
This setting does not initialize any user constants.
A-03: Password 1
A-04: Password 2
These two constants are reserved for the factory to test and set functions.
Users are not allowed to set these two constants.
To Next Page
Loading...
