5.Troubleshooting
Battery Charging and Performance Issues
Problem: No LCD or LED indications, controller does not appear to have
power.
Solution:
With a multi-meter, check the voltage at the battery terminals on the controller. Battery
voltage must be 9 VDC or greater. If the voltage on the battery terminals of the
controller is between 9 and 60 VDC and no LED or LCD indicate, contact your
authorized dealer for service. If no voltage is measured, check wiring connections,
fuses
Problem:
The controller is not charging the battery.
Solution:
If the LCD indicator is normal, check the fuses, breakers and wiring connections in the
solar array wiring. With a multi-meter, check the array voltage directly at the controller
solar input terminals. Input voltage must be greater than the minimum start- up voltage
before charging will begin.
Network and Communication Issues.
Problem:
Cannot connect to the controller via communication port.
6.1 Communication port pinout
Make sure that your cable matches the RS485 communication port. The
communication port is RS485.
To Next Page
Loading...
Need help?
General
