AIPAS A6 - Starting and Riding the eBike; Properly Ending Your Ride

STEP:
1. Insert key and turn counterclockwise to the ON posi tion. The
key will be parallel with the frame.
1. Hold down the button located on
the left handlebar until the display
comes on.
2. Select a Pedal Assist (PAS) level using
the plus (+) and minus (-) buttons. PAS
0 provides no motor assist. PAS 1 is
the lowest level of assist and PAS 5 is
the highest level of assist.
To prevent serious injury or death:
• Exercise extreme caution when using the twist throttle.
When at a complete stop with the bicycle turned ON, be
careful not to twist the throttle or the bicycle could
accelerate and cause you to crash.
• Do not engage Walk Mode when riding or sitting on your
Aipas eBike. Holding the minus (-) button will engage the
motor up to a walking speed.
To end your ride:
When the bicycle is at a complete stop, press and hold the
button to turn the display OFF. This ensures the motor will not
activate until the display is turned ON again and you are ready to
ride.
WARNING!
WWW.AIPASBIKE.COM
46