TROUBLESHOOTING
If you have any questions at all regarding the basic
troubleshooting below, reach out to Aipas eBikes customer
support by email at
service@aipasbike.com, or call (626) 702
-6679.
Issue Most Common Solutions
Pedal assist or
throttle do not work.
1. Check that the PAS level is set
between 1-5.
2. To test if PAS is working, do not
operate throttle.
3. To test if the throttle is working,
do not pedal.
4. Check all quick plugs.
1. Charge the battery until the light
on the charger turns from red to
green. This may take up to 8
hours.
2. Insert key in the battery and turn
counterclockwise to the ON
position, or until the key is parallel
with the frame. Then press and
hold the button to turn ON.
3. Follow the cable coming from the
display down to the quick plug. You
may need to unravel some of the
plastic wrapping to access it. With a
quick pull (do not twist),unplug the
quick plug, inspect both sides of
the plug, and reconnect by lining up
the arrows on both ends. After
checking the quick plug, press and
hold the button on the display
control pad to turn on.
Bicycle will not turn ON.
To Next Page
Loading...