Tune-Ups
100 Mile Tune-Up
After 100 miles, or 5 full battery charge cycles, have the
following services performed at a bicycle shop:
• Brake cables may need to be adjusted and tensioned properly.
• Shifting cables will stretch during the wear -in period. The
derailleur may need to be adjusted.
• All hardware should be adjusted to the specified values,
found in “Tightening Torque” on page 27. If any hardware
is damaged, it may need to be replaced by a bicycle
mechanic.
Monthly (or about every 250-500 miles)
• Inflate tires to pressure within recommended range
printed on tire sidewalls.
• Lubricate chain.
• Check that all hardware is tightened to the torque
specifications listed in the “Tightening Torque” on page 27
of this manual.
• Check your brake pads for signs of wear. Replace if necessary.
• Check your bicycle’s shifting performance. Adjust the
derailleur if necessary.
• Clean the bicycle with low residue cleaner and dry
completely. Lubricate after cleaning where necessary.
• Check spoke tension and adjust if necessary. See
“Tightening Torque” on page 27.
Quarterly (or about every 750-1500 miles)
• Check all items on the monthly s ervice list above.
• Check tire tread for excessive wear. Replace if necessary.
• Check eAipasal connectors and cable housings are secured
away from moving parts and are free from damage. Replace
if necessary
To Next Page
Loading...