QR Code
Place
Holder
This operation guide describes the basic
functions of your GT Series Tenant Station
12 / 2016
Use the
dial to
adjust the
LCD screen
brightness
levels (0~10).
LCD Screen
Brightness
Control
Use the dial
to adjust the
communication
volume (0~10).
Volume
Control
Use the dial to
adjust the chime
volume (0~10). The
status indicator light
blinks slowly when
the chime is muted.
Chime Volume
Control
Push the door release
button to unlock the
entrance during a call.
Door Release Button
Push the option
button to activate
an external device
(if included).
Option Button
Touch the guard button to call all guard and concierge
stations connected to the system (if included). To view
a visitor on a CCTV camera (if enabled), push the guard
button while in communication with the entrance station.
Guard Button
Touch the adjust button to compensate
for low or bright backlight conditions
when viewing video from a door station.
Adjust Button
Touch the zoom / wide button
to change the screen view.
Zoom / Wide Button
Touch , , , or
to change the camera
view (zoom‑view only).
Camera Control Buttons
Push the talk / off button to answer an incoming call.
Once answered, conversation becomes hands‑free.
Push the talk / off button again to end a call (this does
not turn off the station). For push‑to‑talk (PTT) mode,
push the TALK button until a beep is heard. The conversation
then requires the TALK button to be pushed and held while
talking and released while listening. To end the PTT
conversation, push the TALK button one time without holding
(this does not turn off the station). Whether the conversation
is hands‑free or PTT, the talk indicator light turns on while
you speak and will turn off while your visitor speaks.
Talk / Off Button
LCD Screen
Mic
GT-1C7 Tenant Station
GT‑1C7 Operation Guide
|
1 of 1
For a complete operation manual (3.71 MB), scan QR code or use link to download
it from the manufacturer’s website: www.aiphone.com/gt-1c7_op-man
The speaker is
located on the back.
Speaker
Status
Indicator
Light
This tenant station is powered by the system and
will always remain on, even when the screen is
off. Contact the building manager if the tenant
station in this residence is not working.
Power Source
Need help?
General
