5
Step 5: Association Settings (continued)
Figure 5-B: Association Setting Window (Station Settings List / Station List)
Figure 5-C: Association Setting Window (Associated Stations List)
Stations that have been associated will appear in the Associated Stations List (bottom window).
Repeat steps above until all stations have been associated (see Figure 5-C).
Step 5.5 Click to save changes.
When the Association Setting window appears:
Step 5.2 Select a station from the Station Settings List (upper window).
Step 5.3 Select a station from the Station List (middle window).
Step 5.4 Once both have been selected, click (see Figure 5-B).
Step 5.5
Step 5.2
Step 5.3
Step 5.4
Ensure the same Type of
station is being selected from
each list. For example, both
should be Master Stations or both
should be Audio Only Door Stations.
Note:
Stations will reboot after being associated.
This could take up to 10 minutes.
Note:
To Next Page
Loading...
