4 | IX Quick Start Programming Guide
Step 4: Network Settings
Step 4.1 From menu on left, under Network Settings, select IP Address.
- Click on
Batch IP Address Confi guration
.
Step 4.2 Enter starting IP Address, and Subnet Mask (see Figure 4-A).
Step 4.3 Select All from the Select Station(s) by type drop-down menu to apply IP Address and Subnet Mask to all stations.
- Click
.
- Click
.
Step 4.4 A pop-up will occur asking Select Station’s IP Address will be batch confi gured. Continue? (see Figure 4-B).
- Click
.
Step 4.5 Click on the main page to save changes.
Figure 4-A: Batch IP Address Confi guration
Step 5.1 From the Tools(T) drop-down menu, select Association Settings (see Figure 5-A).
Step 5: Association Settings
Figure 5-A: Association Settings
Figure 4-B: Continue?
Step 4.4
Step 4.2
Step 5.1
Step 4.3
Enter the IP address and subnet
mask individually when not
using the Batch IP Address
Confi guration.
Note:
To Next Page
Loading...
