- 2 -
Notice
• If the station is used in areas where there are business-use wireless devices such as a transceiver or mobile phones, it may
cause malfunction.
• If the station is installed in an area with an extremely strong electrical field, such as in the vicinity of a broadcasting station, it
may create interference and cause malfunction.
• A human body detection sensor detects temperature changes within the detection range, but it may not detect or the sensitivity
may change depending on the ambient temperature and environment.
Precautions for mounting
• Installing the station in the following locations as is may affect the clarity of the image:
– Where the device is installed in a dark location and there is light behind the subject
– Where lights will shine directly into the camera at night time
– Where direct sunlight is present
• Installing the device in the following locations could cause malfunction:
– Locations under direct sunlight
– Locations near heating equipment
– Locations subject to liquid, iron filings, dust, oil, or chemicals
– Locations subject to moisture and humidity extremes
– Locations where the temperature is quite low
– Locations subject to steam or oil smoke
– Sulphurous environments
– Locations close to the sea or directly exposed to sea breeze
• In 50Hz regions, if a strong fluorescent light enters directly into the camera, it may cause the image to flicker. Either shield the
camera from the light or use an inverter fluorescent light.
• If existing wiring is used, the device may not operate properly. In that case, it will be necessary to replace the wiring.
• Do not use an impact driver to fasten screws. Doing so may cause damage to the device.
• IXG-MK, IXGW-LC, IXGW-GW is designed for indoor use only. Do not install at outdoor location.
• Observe the following restrictions for installing entrance stations.
– When cleaning the wall with a high-pressure washing machine, avoid to spray on the entrance station.
– Do not mount the entrance station so that if faces obliquely upward.
– Do not block the bottom of entrance station by caulking.
• Avoid installing the master monitor station in concave space of a wall to prevent disconnection of communication.
• If the LCD display comes into contact with rain, it may not respond when touched or cause false reactions to occur. Please
install the unit in an area where it doesn’t come in contact with rain.
To Next Page
Loading...
Need help?
General
