Aiphone IXGW-GW - How to Install; IXG-MK Wall Mounting; IXG-MK Desktop Stand Mounting

14 | IXG Commercial Quickstart Guide SIP
IXW-MA Conguration Cont.
Conguring the IXW-MA
The IXW-MA will now need to be congured, which is done via web browser. Open any modern browser (Aiphone
recommends Microsoft Edge or Google Chrome) and enter the following: https://192.168.1.160/webset.cgi?login
Depending on the chosen browser, a certicate warning or error may be given.
Choose to proceed anyway to reach the login screen.
ID and Password
Once the login screen is reached, enter admin for both the ID and Password. The IXW-MA
will then require that a new ID and Password be created. For best practice, use the same ID
and Password created in IXG Support Tool for the other stations in the system.
Relay Settings
From the left hand side menu, nd Option Input/Relay Output and select Relay Output.
Starting with Relay Output 1, select Contact Change SIF Event and then specify the Station Number
of the station activating the Relay Output 1. Once these values are set, click
Update
. Depending
on the browser, the IXW-MA may return to the login screen when Update is clicked.
Repeat these steps for each Relay Output, which selected from the drop-down at the top of the Relay Output section.
Network Settings
For the nal step, nd Network Settings and select IP Address from the left hand side menu. Assign
the adaptor the desired IP Address, Subnet Mask, and Default Gateway. The given IP address must
match the value entered in Support Tool under Function Settings, SIF. When nished, click
Update
.Updating the network settings will cause the adaptor to reboot, which may take up to 5 minutes.
Once all of the hardware is rebooted, the system is ready to test.
For Door Release, the
SIF Origination Station
Number should be that
of the door station.