Aircat 6280 - Important Warnings - Grinders & Cut-Off Tools; Operational Warnings; Accessory and Tool Usage; Safety and Personal Protective Equipment

SPECIFICATIONS
Important Warnings - Grinders & Cut-Off Tools
Tools of this class operate on a wide range of air pressure. It is recommended that air pressure of these tools measures 90 PSI at the tool while running free. Higher
pressure and unclean air will shorten the tool’s life because of faster wear and may create a hazardous condition and void the warranty. Water in the air line will
cause damage to the tool. Drain the air tank daily. Clean the air inlet lter screen on at least a weekly schedule. The recommended hookup procedure can be viewed
in the illustration below. The air inlet, used for connecting air supply, has standard 1/4” NPT and 1/4“ BSP thread.. Line pressure should be increased to compensate
for unusually long air hoses (over 25 feet). Minimum hose diameter should be 3/8” I.D. and ttings should have the same inside dimensions.
Air Supply
Model No.
Free Speed
(RPM)
Motor
(HP)
Collet Size
(in)
Gears Exhaust
Weight
(lbs.)
Length
(in)
Air Cons.
(CFM)
Rec.
Hose Size
(in.)
Air Inlet
(in.)
NPT/BSP
6280 18,000 0.7 1/4
5:1 Ratio Bevel
Rear 1.8 7 4.1 3/8 1/4