Aircotec XC-trainer Series - Sink Acoustic Tone Control; Sink Tone Activation Threshold; Sink Tone Modulation; Sink Tone Inversion

Manual V1.00_2009_V5
15.0 VARIO-SETTINGS
General SETTINGS
1. Bring the cursor to the desired position using Key1
or Key2
2. Use Key3
to call a particular field to set
3. Use Key1
or Key2 to increase/decrease values or to confirm/ cancel (Y/N)
4. Use Key3
to store and activate changes
15.1 Sink acoustic ON / OFF
This is of particular relevance for acro pilots as the sink tone is
set to commence at -5m/s. With this setting, this function may
be deactivated.
„SINK TONE Y“ Sink tone active
„SINK TONE N all Sink tones off
15.2 Sink tone threshold „SINK – 1.0m/s“
Use this function to set the sink tone threshold from 0,0 -
5,0m/sec. When set to -5,0m/s the Sinktone is off, as from.
-5 m/sec the sink alarm sets in.
15.3 Sink tone modulation „SINK MOD N“
If set to N
If set to
Y
15.4 Sink tone Invers „SINK INV N“
If set to N – the greater the sink, the deeper the tone
If set to Y – the greater the sink, the higher the tone
15.5 Vario sensitivity „VAR TC .5s“
Adjustable from 0,5 – 4sec Integrated (cumulative Vario values as function of the time set).
15.6 VOLUME „Volume 2“
Adjustable from 0 – 3 , where 0 = OFF 1 = LOW 2 = MEAN 3 = LOUD
May also be set during flight by going to VARIO mode ( see 7.5 ).
Page 30