EasyManua.ls Logo

AirKing 9418 User Manual

AirKing 9418
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
18” PEDESTAL FAN
18” (45,7 cm) MODEL 9418
1
Rev. B 5/08
5084034
DESCRIPTION
The Air King® 18” (45,7 cm) pedestal fan features 3-speed rotary knob
operation with a 3-paddle fan blade and variable height adjustments.
This fan has a permanently lubricated motor with a 9 ft. (2,74 m) 18/3
cord set and is constructed of sturdy, powder coated steel.
SPECIFICATIONS
Motor ...................................... 120 V, 60 Hz
Blade diameter ....................... 18” (45,7 cm)
Speeds .................................... 3
Control .................................... Rotary Switch
Air flow distribution ................ 360°
Approvals ................................ ETL Listed. Close mesh fan guard
meets OSHA requirements.
ASSEMBLY
TOOLS REQUIRED FOR ASSEMBLY
•HexWrench(SuppliedinPartsBag)
NOTE: ALL HARDWARE REFERRED TO IN THE INSTRUCTIONS MAY
BE FOUND IN THE SUPPLIED PARTS BAG.
1. Lay Fan Head on flat surface, so the front side is facing down. Hold Yoke
so the side with the nut is facing up. Loosely attach one Grill Knob and
one Rubber Spacer to the Head Assembly. Attach the other Grill Knob
and Rubber Spacer to the Head Assembly and FIRMLY tighten. Return
to the first Grill Knob and FIRMLY tighten. (Figure 1)
NOTE:
THE UPPER PIPE HAS 2 BUMPS, ONE AT EACH END. THE BUMP
CLOSER TO THE END OF THE PIPE INDICATES THE TOP. THIS END
FITS INTO THE YOkE.
2. MakesureBumponUpperPipeisalignedwithformedsectionofYoke.
InsertUpperPipeintoYoke.Toensuretistight,twistUpperPipeuntil
it is tight inside of Yoke. (Figure 1)
NOTE: THE UPPER PIPE SHOULD FIT COMPLETELY INSIDE OF THE YOkE.
GENERAL SAFETY INFORMATION
When using electrical appliances, basic precau-
tions should always be followed to reduce the
risk of fire, electric shock and injury to person,
including the following:
1. Read all instructions before using Fan.
2. Make certain that the power source conforms to the
electrical requirements of the Fan.
3. Use this Fan only as described in this manual. Any other
use not recommended by the manufacturer may cause fire,
electrical shock, or injury to persons.
4. Unplug power cord before installing, servicing, or moving the Fan.
WARNING: DO NOT DEPEND UPON THE ON-OFF
SWITCH AS THE SOLE MEANS OF DISCONNECTING
POWER WHEN INSTALLING OR SERVICING THE FAN.
ALWAYS UNPLUG THE POWER CORD.
5. This Fan must NOT be used in potentially dangerous
locationssuchasammable,explosive,chemical-laden
or wet atmospheres.
6. The power cord is equipped with a three-prong grounded
plug that must be inserted into a matching receptacle. Under
no circumstances should the grounding prong be cut off the
plug. Wherea two-prong wallreceptacle is encountered,
it must be replaced with a properly grounded three-prong
receptacle installed in accordance with the National Electrical
Code (NEC) and all applicable local codes and ordinances.
This work must be done only by a qualified electrician, using
copper wire only.
WARNING: DO NOT USE A THREE-PRONG ADAPTER.
IMPROPER CONNECTION MAY CREATE THE RISk OF
ELECTRIC SHOCk. USE OF SUCH ADAPTERS IS NOT
PERMITTED IN CANADA.
WARNING: THIS PLUG IS A SAFETY FEATURE. TO
REDUCE THE RISk OF FIRE, ELECTRIC SHOCk AND
PERSONAL INjURY, DO NOT REMOVE, REPLACE,
REPAIR OR TAMPER WITH THE ORIGINALLY SUPPLIED
PLUG. IF THE FAN DOES NOT FUNCTION PROPERLY, IT
MAY BE DUE TO THE SAFETY DEVICE INCORPORATED
IN THIS PLUG.
7. Wherepossible,avoidtheuseofextensioncords.Iftheymust
be used, minimize the risk of overheating by ensuring that they
areULlisted.Neveruseasingleextensioncordtooperate
more than one Fan.
8. Do not operate any Fan with a damaged cord or plug after
the Fan malfunctions, has been dropped or damaged in
any manner. Return Fan to authorized service facility for
examination,electricalormechanicaladjustmentorrepair.
9. Do not insert or allow fingers or foreign objects to enter any
ventilation or exhaust opening as it may cause an electric
shock, fire, or damage the Fan. Do not block or tamper with
the Fan in any manner while it is in operation.
10.Always place the Fan on a stable, flat, level surface when
operating, to avoid the chance of the Fan overturning. Locate
thePowerCordsotheFanorotherobjectsarenotrestingonit.
DonotrunPowerCordundercarpeting.DonotcoverPower
Cordwiththrowrugs,runners,orthelike.ArrangePowerCord
away from room traffic and where it will not be tripped over.
11.This Fan is not intended for use in wet or damp locations.
Never locate a Fan where it may fall into a bathtub or other
water container.
12.Do not use Fan outdoors.
13.
ThisFanisnotsuitableforuseinhazardouslocations.Pleaserefer
to National Electric Code (NEC) Article 500 or applicable state
or local codes or standards relating to electrical requirements
for Hazardous locations. THIS FAN DOES NOT MEET THE
REQUIREMENTS OF NEC ARTICLE 500 (2008).
WARNING: REDUCE THE RISk OF FIRE OR ELECTRIC
SHOCk DO NOT USE THIS FAN WITH ANY SOLID STATE
SPEED CONTROL DEVICES.
READ AND SAVE THESE INSTRUCTIONS
READCAREFULLYBEFOREATTEMPTINGTOASSEMBLE,INSTALL,OPERATEORMAINTAINTHEPRODUCTDE-
SCRIBED.PROTECTYOURSELFANDOTHERSBYOBSERVINGALLSAFETYINFORMATION.FAILURETOCOM-
PLYWITHINSTRUCTIONSCOULDRESULTINPERSONALINJURYAND/ORPROPERTYDAMAGE!
RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
OPERATING INSTRUCTIONS & PARTS MANUAL
SAVE THESE INSTRUCTIONS
Question and Answer IconNeed help?

Do you have a question about the AirKing 9418 and is the answer not in the manual?

AirKing 9418 Specifications

General IconGeneral
BrandAir King
Model9418
Blade Size18 inches
Speed Settings3
OscillationNo
Power SourceCorded Electric
Voltage120 V
Blade MaterialMetal
Power Consumption120W
Amps1.0 Amps
Housing MaterialSteel

Summary

Product Description and Specifications

Product Description

Details the Air King 18" pedestal fan's features like 3-speed rotary knob, 3-paddle blade, variable height, and durable construction.

Product Specifications

Lists technical details including motor voltage, blade diameter, speeds, airflow distribution, control type, and approvals.

General Safety Information and Warnings

Essential Safety Precautions

Basic precautions for using electrical appliances to reduce risk of fire, electric shock, and injury, including reading instructions and proper grounding.

Specific Safety Warnings

Highlights crucial warnings regarding plug adapters, extension cords, fan placement, and avoiding hazardous locations.

Fan Assembly Instructions

Tools Required for Assembly

Lists the necessary tools for assembling the pedestal fan, including a supplied hex wrench.

Assembly Procedure

Step-by-step guide for assembling the fan head, upper pipe, yoke, and lower pipe, ensuring secure connections.

Fan Operation Guide

Adjusting Fan Height and Angle

Instructions on how to adjust the fan's vertical height and tilt the head using the knobs, with safety cautions.

Operating the Fan

Guide on plugging in the fan, selecting desired speed, and environmental usage recommendations.

Fan Maintenance and Storage

Maintenance and Cleaning

Procedures for cleaning the fan using mild soap and water, with warnings against harsh chemicals.

Storage Recommendations

Advice on storing the fan in a clean, dry place when not in use.

Limited Warranty Information

Warranty Coverage Details

Outlines what is covered by the warranty, including defects in workmanship and materials.

Warranty Limitations and Exclusions

Specifies what is not covered, such as accidental damage, misuse, and unauthorized repairs, and liability limits.

Related product manuals