AirLive WL-1200CAM - User Manual

Questions and Answers

L
Lorraine RodriguezAug 11, 2025
Why is my AirLive WL-1200CAM image refreshing so slow?
- M
  Michelle MendezAug 11, 2025
  If your AirLive IP Camera image refreshes slowly, there are several adjustments you can make: * Try increasing the frame rate, especially if it's not already set to 30. * Reduce the resolution to see if that improves the refresh rate. * If you're viewing the camera remotely, a slow Internet connection could be the cause. Try lowering both the frame rate and resolution. * Adjust the antenna for better wireless reception. Ensure it's perpendicular to the ground and that the camera isn't too far from the wireless access point. * If you use PPPoE, adjust the 'MTU' setting with guidance from your ISP or network administrator.
H
heidiwashingtonAug 17, 2025
What to do if AirLive IP Camera is not responding?
- M
  Michelle RamosAug 17, 2025
  If your AirLive IP Camera is not responding, try the following steps: 1. Check the network cable or wireless connection to ensure it is properly connected. 2. Unplug the power adapter from the wall socket, wait 10 seconds, and then plug it back in. Then, try connecting to the IP camera again.
D
daniel93Aug 25, 2025
Why is the image from my AirLive WL-1200CAM fuzzy?
- M
  matthewpetersonAug 26, 2025
  If the image from your AirLive IP Camera appears fuzzy, here are a few things you can try: * Adjust the focus ring on the camera until the image becomes clear. * Clean the lens with a soft, dry cloth. You can use a cloth with water, but avoid alcohol or other chemical solutions. * Adjust the brightness setting to see if it improves the image. * If possible, turn on any lights in the camera's location to see if that makes a difference.
V
Victoria MeyerSep 2, 2025
What to do if AirLive WL-1200CAM doesn't send images by Email or FTP?
- J
  Jerry MartinezSep 2, 2025
  If you are not receiving images from your AirLive IP Camera via Email or FTP, consider the following: * If sending via Email, ensure that the emails are not being blocked by any anti-spam filters. * Verify that you have sufficient permissions for FTP uploading. You can test this by clicking the 'Upload a test file' button. * If your SMTP server requires authentication, confirm that the username and password are correct by clicking the 'Send a test Email' button. * Review the log for any failed FTP uploads or Email sending attempts, as this may provide clues to the problem. * Adjust the threshold to a more sensitive setting.