What to do if my Airrex AH-600 stops immediately after ignition?
If your Airrex Heater stops immediately after ignition, check if the "Lack of Fuel" light is on and fill up the fuel if needed. Verify that you are using either Diesel or kerosene and drain/replace the fuel if there are any impurities or other types of fuel. Ensure the flame sensor is correctly located. Finally, remove any air in the electric pump if there's noise.
How to fix no ignition on burner in Airrex AH-600 Heater?
If there is no ignition on the burner of your Airrex Heater, the fuel filter may be clogged. Clean the filter with compressed air or replace it with a new one. Also, if the voltage is low, the burner will not work properly, so use a booster to elevate the voltage.
What to do if my Airrex AH-600 is not working?
If your Airrex Heater isn't working, first ensure it's properly connected to a power supply (220/230V a.c. 50Hz). Check that the power plug is securely plugged into the outlet. Also, inspect the fuse and replace it with a new one (250V a.c. 3A) if it's shorted.
Instructions for starting, stopping, and basic operation of the heater.
Guide on setting and adjusting the desired temperature for automatic heating.
Explanation of error codes and self-diagnosis for safety device issues.
Common problems, their causes, and solutions for heater malfunctions.
Technical specifications for different models and the heater's electrical wiring diagram.
General| Model | AH-600 |
|---|---|
| Adjustable Thermostat | Yes |
| Overheat Protection | Yes |
| Oscillation | No |
| Fuel Type | Kerosene |
| Heating Element | Infrared |
To Next Page
