What to do if my Airrex Heater stops immediately after ignition?
If your Airrex Heater stops immediately after ignition, check if the "Lack of Fuel" light is on and fill up the fuel if needed. Verify that you are using either Diesel or kerosene and drain/replace the fuel if there are any impurities or other types of fuel. Ensure the flame sensor is correctly located. Finally, remove any air in the electric pump if there's noise.
How to fix no ignition on burner in Airrex Heater?
If there is no ignition on the burner of your Airrex Heater, the fuel filter may be clogged. Clean the filter with compressed air or replace it with a new one. Also, if the voltage is low, the burner will not work properly, so use a booster to elevate the voltage.
What to do if my Airrex Heater is not working?
If your Airrex Heater isn't working, first ensure it's properly connected to a power supply (220/230V a.c. 50Hz). Check that the power plug is securely plugged into the outlet. Also, inspect the fuse and replace it with a new one (250V a.c. 3A) if it's shorted.
Critical safety warnings regarding potential hazards like fire, electric shock, and injury.
Further critical safety warnings on operation, placement, and usage of the heater.
Explanation of self-diagnosis features, error messages, and safety device triggers.
Solutions for issues like no power, no fan motor operation, and failure to ignite.
Diagnosing and resolving problems related to immediate stops, excessive soot, and burner noise.
General| BTU Output | 80, 000 BTU |
|---|---|
| Heating Area | 800 sq ft |
| Fuel Type | Diesel / Kerosene / JP8 / Fuel Oil |
| Fuel Consumption | 0.67 gal/hr |
| Tank Capacity | 13 Gallons |
| Thermostat | Yes |
| Power Consumption | 200W |
| Voltage | 120V |
| Weight | 80 lbs |
| Dimensions | 35" x 17" x 21" |
| Power | Electric |
| Frequency | 60 Hz |
| Safety Features | Overheat Protection, Tip-Over Protection, Flame-Out Sensor |
To Next Page
