AirSep NewLife Intensity 10 Service Manual

NewLife
®
Intensity 10
Oxygen Concentrator
Service Manual

AirSep NewLife Intensity 10 Specifications

General

Brand	AirSep
Model	NewLife Intensity 10
Category	Medical Equipment
Language	English

Summary

1.0 Introduction

1.1 Equipment Provider Responsibility

Outlines responsibilities for handling, operational check-out, patient instruction, and oxygen concentration checks.

1.2 Important Notice and Symbol Explanations

2.0 Operational Check and Oxygen Concentration Test

2.2 Operation Check

Details pre-delivery inspection and functional tests to ensure proper operation and detect shipping damage.

2.3 Alarm System

2.4 Oxygen Concentration Test and Specification

Outlines the procedure to test and verify oxygen output concentration against specifications.

4.0 Provider Instructions

4.1 Instructions

Covers oxygen concentration testing protocols and the lack of required preventative maintenance for the unit.

4.1.4 Battery Replacement

4.2 Preparing for New Patient Use/Method of Cleaning and Infection Control

5.3 Compressor

5.3.1 Compressor Replacement

Details the step-by-step process for removing and installing the compressor assembly.

5.3.2 Capacitor Replacement

5.5 Sieve Beds

5.5.1 Sieve Bed Replacement

Provides instructions for removing and installing sieve beds, emphasizing replacing both simultaneously.

5.7.1 Circuit Board Replacement

5.9 Product Regulator Check and Setting

5.9.1 Setting Product Regulator for Normal Operation

Provides a step-by-step guide to set the product regulator to the correct operating pressure.

5.9.2 Product Regulator Cleaning or Rebuilding

5.16 Oxygen Monitor Circuit Board Replacement

6.0 Troubleshooting

6.1 Operating Pressure Test

Explains how to perform an operating pressure test to diagnose low oxygen concentration issues.

6.1.1 High Operating Pressure

6.1.2 Low Operating Pressure

6.2 General Troubleshooting

6.3 Troubleshooting Chart

6.4 Tool Kit and Pressure Test Gauge