System Update
Figure 7-6 Master/HVAC Status
3. Select “Upgrade” tab on the left.
4. Click “Choose File” under “C.pCO AP1 Upgrade” and select the previously downloaded AP1 file.
Figure 7-7 File Selection Screen
5. Click “Upgrade AP1 to c.pCO”, the upgrade process will start.
6. Once the upgrade is complete, the status will display “Upload successful”. This may take up to 5 minutes.
7. Repeat steps 1-5 for all HVAC units.
Step 2: Save Controller Settings
The software upgrade procedure will reset all settings to factory defaults. Some settings must be manually
reconfigured. Complete the following steps using the ASMUC web interface.
1. Navigate to the IP address of the multi-unit controller.
•
If unsure, navigate to “Controller Interface” tab. Master Controller/HVAC status will be displayed on the
main page.
2. Navigate to the “Controller Interface” tab.
3. Press Prg (ʘ) and enter the default password (0004). Press Enter.
4. Press Up or Down to reach “Control Config” and press Enter.
Press Enter at “Network”.
5. Record all network settings (i-iv). Press Down to access each individual screen.
•
Total # of HVAC and Total # of Zones
To Next Page
Loading...
