How to fix AirTek Air Conditioner that is not working?
If your AirTek Air Conditioner isn't working, here's what to check: * Make sure the plug is properly inserted into the power socket. If not, plug it in correctly. * Verify that there's sufficient amperage to start the unit by checking the fuses. * See if the water tank is full and the alarm light is on; if so, drain the unit.
Why my AirTek MOB-10KDCHR Air Conditioner does not cool effectively?
If your AirTek Air Conditioner isn't cooling effectively, consider these possible reasons: * The room might be too large for the unit. Use it in a room within the recommended size. * Direct sunlight might be affecting the unit's performance. Close curtains and pull down blinds. * Open windows or doors can reduce cooling efficiency. Ensure they are closed. * Another heat source in the room may impact cooling. Remove any heat sources. * A dusty or contaminated filter can hinder performance. Clear the filter. * The air intake might be blocked. Check and remove any obstacles.
What to do if my AirTek MOB-10KDCHR cuts out?
If your AirTek Air Conditioner keeps cutting out, here are some things to check: * Ensure the unit is at least 500mm away from walls and other objects. * Make sure the appliance isn't covered, as this can cause overheating. * Check if the 'timer off' function is activated, and if so, press the power button to turn the unit on. * Verify that the room temperature is between 61°F and 97°F (16°C and 36°C). If not, switch the unit back on when it is.
What does it mean when the RUN LED flashes and alarm sounds on AirTek MOB-10KDCHR Air Conditioner?
If the "RUN" LED indicator light flashes and the alarm sounds on your AirTek Air Conditioner, it means the condensation tank is full and the unit can't drain. To resolve this, drain the unit from the drain plug at the back.
What does E7 mean on my AirTek MOB-10KDCHR Air Conditioner?
If "E7" is displayed on the LED panel of your AirTek Air Conditioner, it means the water tank is full. Drain the water tank; the appliance will switch on when the water tank has been emptied.
How to reduce noise from AirTek MOB-10KDCHR?
If your AirTek Air Conditioner is too noisy, it might be positioned on an uneven hard floor surface, creating vibration. Placing it on a soft carpeted surface may absorb excessive vibration.
Why my AirTek Air Conditioner's LED is on but it is not running?
If the LED display shows the unit is set but it is not running on your AirTek Air Conditioner, the "timer on" feature is likely activated. Push the Power button to turn the unit on and deactivate the "timer on" feature.
Provides essential safety guidelines to follow before operating the air conditioner to prevent hazards.
Details methods for attaching the exhaust hose to windows or walls for proper ventilation.
Describes the control panel layout, LED indicators, and buttons for operating the unit.
Instructions for inserting batteries, pointing, and basic usage of the remote control for the appliance.
Explains how to adjust the louvers for directing the airflow up, down, left, or right.
Guidance on how to clean the external body of the air conditioner using appropriate methods.
Instructions for removing, cleaning, and refitting the air filter to maintain efficiency.
Steps to follow for storing the unit correctly when not in use for extended periods.
General| Brand | AirTek |
|---|---|
| Model | MOB-10KDCHR |
| Category | Air Conditioner |
| Language | English |
To Next Page
