5
HOW DO I USE THE IONIZER?
Please make sure you have the correct number of units for your pool. One unit is
good for up to 35,000 gallons of water. You may need two or more depending on your
pool size.
1. Before using the ionizer, clear the pool water to eliminate most of the algae. The
ionizer can’t kill current algae so please use a dose of oxidizer/chlorine according
to the pool condition before using the unit.
2. Simply leave the ionizer in your pool under direct sunlight. It needs at least 4-5
hours in the sun for the solar panel to work.
3. Do not use any other chemicals in your pool. The process needs a few weeks to
see differences and other chemicals in your water may affect the performance. Please
be patient.
4. The solar pool ionizer works well at higher pH values, so do not attempt to adjust
the pH if it is within this recommended range of 7.2-7.8. Allow the water to settle down
and seek its own balanced condition.
5. Higher chlorine levels may be required with increased water temperature, rainfall,
or if new water is added. If using liquid chlorine, add it at or after sundown because
sunlight quickly neutralizes chlorine.
4. Thread the screw clockwise into the anode and tighten. Do not over-tighten because
the screw may break.
You can replace the silicone band when it is dirty or broken.
The purpose of the basket is to trap any deposits or residues which may form on the
anode during normal operation. The basket prevents particles from falling into the
water.
Note:
To Next Page
Loading...