What to do if the LCD display is corrupted on AirTouch Control Systems?
If the LCD display on your AirTouch Control System is corrupted, first reset it by holding the RESET button on the right side of the console for two seconds. If the error persists, reset the console by unplugging the cable from behind and reconnecting it after about 15 seconds. If the display remains corrupted after these steps, the console may need to be replaced.
Why some zones cannot be turned off in AirTouch Control Systems?
If some zones cannot be turned off on your AirTouch Control System, check if the ‘Spill’ status is displayed for the zone. Opening other zones may rectify the error. Also, check spill groups.
What to do if there is no display on the LCD of AirTouch Control Systems?
If there is no display on the LCD of your AirTouch Control System, ensure that the cable is properly plugged in. Try unplugging the cable and reconnecting it. Also, verify that there is power to the unit.
General| Input Types | Temperature sensors |
|---|---|
| Operating Temperature | 0°C to 50°C |
| Connectivity | Wi-Fi |
| Display | Touchscreen |
| Features | Multi-zone control |
| Communication | Wi-Fi |
| Power Supply | 24V DC |
To Next Page
