- 06 -
Battery removal instructions
Before removing, check whether the power is off, open the box, pull
open the lining zipper, open the inner lining, unplug the battery cable,
pull out the cloth tape outside the battery box forcefully, and the battery
will be lifted up and remove the battery.
(When the battery is taken out for the first time, the fixed tie on the
battery box needs to be cut and removed.)
Custom coded lock instruction
The original password is 0-0-0, set your own password, follow these steps:
1.Dial the password to the original password: 0-0-0;
2.Press the button A with a pen or other tool until you
hear the 'tick' sound;
3.Dial the password wheel B to set your own password,
for example: 8-8-8;
4.Push button C in the direction of the arrow and hear the “tick” sound
again. Button A pops up and the password is successfully set.
Now you have completed your password setup, please keep it in mind. If you need to reset your password,
repeat the above steps.
A
C
B
Battery Extension Cable Instructions (Optional)
Battery wiring
When the battery is removed for charging, connect the battery and charger as shown below.
Connect battery Connect charger
Battery connector terminal plug Note
：
When inserting the battery cable terminal, please make sure
the terminal "+" pole to the "+" pole, "-" pole on the "-" pole (see
right diagram); never insert positive to negative poles.
WARNING
battery box
battery
tie
cloth bag
+
-
+
-
To Next Page
Loading...
Need help?
General
