Airworks 12 000 BTU - User Manual

Questions and Answers

S
sandralinAug 8, 2025
How to fix Airworks 12 000 BTU that does not operate?
- Y
  Yvette BarnesAug 9, 2025
  If your Airworks Air Conditioner isn't operating or only runs in fan mode, first, ensure the power cord is securely plugged into the wall outlet and that the main power supply is on. If there was a power failure, wait for the power to restore and then wait 3 minutes before restarting the unit. Check if the timer is on and adjust the time settings if needed. Finally, if the LCDI Plug has tripped, press the RESET button on the plug until it clicks.
J
jeffrey72Aug 15, 2025
Why is my Airworks Air Conditioner not cooling efficiently?
- D
  Denise TaylorAug 15, 2025
  If your Airworks Air Conditioner's cooling isn't efficient, start by clearing any obstructions from the air inlets and outlets, such as curtains or blinds. Eliminate any heat sources in the room. Clean the air filter. Adjust the set temperature to a more suitable level. If the fan speed is set to Low or the mode is set to Energy Saver, increase the fan speed or change the unit mode. If the unit is freezing, causing ice blockage, set the highest fan speed and coolest temperature and wait for the frost to melt.
J
Jennifer MartinezAug 22, 2025
What to do if Airworks 12 000 BTU starts and stops frequently?
- M
  Michelle CoxAug 23, 2025
  If your Airworks Air Conditioner starts and stops frequently, or frequently blows fuses or trips the circuit breaker, ensure the outdoor temperature is within the unit's working range (above 17°C or 62°F). Verify that the power source voltage is properly rated according to the unit's rating plate and adjust if necessary. Also, make sure the unit is plugged in alone and not connected to an extension cord or sharing a circuit with other appliances. For dirty or obstructed internal evaporator and outside condenser coils, contact customer service.
K
kaitlynmillerAug 30, 2025
Why does water drip from my Airworks 12 000 BTU Air Conditioner inside the house?
- C
  Christina JonesAug 30, 2025
  If water drips from your Airworks Air Conditioner into the house, it might not be correctly installed and properly leveled. Reposition the unit so it slightly slopes downward to the outside. Avoid drilling any holes in the bottom of the metal base and condensation pan.