AIS Divi - Power Poles and Workstation Accessories; Power Pole Assembly and Mounting

Revised 02.19.10 www.AIS-INC.com 25
AIS DiVi Installation Instructions (P-DVINSTRUCT01)
Install #8-32 hex nuts on the
bottom studs of the 2-way
power pole shroud. Do not
fully tighten nuts. Leave a gap
about 1/16”.
Insert studs of the shroud into
the raceway key slots. Tighten
the nuts.
Place post filler into the 90
degree corner on top of the
base shroud.