Revised 02.19.10 www.AIS-INC.com 28
AIS DiVi Installation Instructions (P-DVINSTRUCT01)
Install the 4 locking screws in
the Pole Coupler.
IMPORTANT- Make sure
screws do not protrude past
back surface of the coupler at
this time.
Slide the bottom half of the
Pole Coupler into the power
pole on the panels. Keep the
coupler as centered on the top
of the power pole as possible.
Tighten the bottom screws to
hold the coupler in place.
Slide the upper section of the
power pole over the
assembled lower section &
Pole Coupler.
Tighten the screws to lock the
upper section of the power
pole in place.
To Next Page
Loading...