Revised 02.19.10 www.AIS-INC.com 45
AIS DiVi Installation Instructions (P-DVINSTRUCT01)
Rest worksurfaces on top of
worksurface supports such
that edges are 1/4 inch from
panel face and that corners
are aligned on the center of
panel corners...
Worksurface should “touch” at
seams and seams should be
aligned with panel seams.
While holding worksurfaces in
place and maintaining
alignment, screw worksurfaces
to cantilevers with screws
provided labeled “For
Worksurfaces”. Use 2 screws
for regular cantilevers and 4
screws for shared cantilevers.
To Next Page
Loading...