Revised 02.19.10 www.AIS-INC.com 47
AIS DiVi Installation Instructions (P-DVINSTRUCT01)
Push drawer in to face, then
open fully and close to ensure
proper slide alignment. IT IS
NOT NECESSARY to actuate
levers on drawer stops while
reinserting drawers. NOTE -
BE SURE TO TEST LOCK ON
PEDESTALS AND adjust as
needed.
Install tackboards by aligning
tackboard brackets with
hanger frame slots
approximate 1 inch above
worksurfaces. Be sure
tasklight cord is behind
tackboard.
Insert tackboard in and down.
Be sure each side if firmly
seated in hanger frame.
To Next Page
Loading...