Humidity Setting
The humidity level can be set within the range of 30% RH to 80% RH in 5% increments.
-When the machine starts working, it will first automatically detect and show the room
humidity. In the dehumidification mode ( not settable under the other modes), press the
"Dehumidify" button to change the humidity selection, each time in 5% increments. The
number indicator "****" will keep flashing and show the set humidity. Once you have settled
the humidity you want, please stop operating and wait for 5 seconds, the number indicator
"****" will stop flashing and turn to show the actual room humidity instead.
-When the humidity level exceeds the set humidity, the dehumidifier will automatically stop
working, while the humidity level falls below the set humidity, it will automatically start
working again.
-When the humidity level is set at 30% RH, the dehumidifier will turn to work in the
continuous dehumidifying mode.
There is Clothes-Dryer Mode, Dehumidify Mode, Continuous Dehumidify Mode.
After the machine is turned on, press the [Mode] button to switch the working modes. Each
time pressing the button, the machine will cycle through the Clothes-Dryer mode, the
Dehumidifying mode, and the Continuous Dehumidifying mode.
Notices:
In the Clothes-Dryer Mode: Both the humidity and fan speed are not settable.
In the Dehumidify Mode: Both the humidity and fan speed are settable.
In the Continuous Dehumidify Mode: The fan speed is settable, while the humidity is not settable.
Time Setting
1. When the machine is turned on, the time setting is used for auto turn-off; When the
machine is turned off, the time setting is used for auto turn-on.
2. Press the "TIMER" button to select the timer, each time in 1-hour increments. You can
set the timer up to 24 hours. It will start to do the countdown when the setting is finished.
3. You can press and hold the "TIMER" button for seconds to make the setting faster.
4. If the time is set at 00, this is called the invalid time which means the time setting is
invalid. Once the time setting is succeeded, the light "o" will light up, and the led screen
will keep showing the setting time for seconds, then turn back to show the current room
humidity.
The time setting is used to set a time for the machine to automatically turn on or turn off.
To Next Page