Aiwa ALP40P User Manual

5
Remove & Close The Lens Cover
Remove the lens cover before using Close the lens cover when unit not in use
LENS COVER
REMOV
E
LENS COVER
CLOSE
Placing Your Projector
Your projector can be installed in four different configurations ( see picture
below):
Front Table:
Select this location with the projector placed
near the floor in front of the screen. This is the
most common way to position the projector
for quick setup and portability.
Front Ceiling:
Select this location with the projector
suspended upside-down from the ceiling in
front of the screen.
NOTE: A projector mount is required to insta
ll
the projector in a ceiling.
Rear Table:
Select this location with the
projector placed
near the floor behind the screen.
NOTE: A special rear projection screen
is required.
Rear Ceiling:
Select this location with the projector
suspended upside-down from the ceiling
behind the screen.
NOTE:
A projector mount is required to install the
projector in a ceiling.
A special rear projection screen is required.
FRONT TABLE
FRONT CEILING
REAR TABLE
R
EAR
CEILING

Aiwa ALP40P Specifications

General

Light Source Type	LED
Brightness Output	LED bulb 2800 Lumens White light output 40 Lumens
Display Native Resolution	800 x 480
Display Color	16.7K
Projection Size	30-150 inch
HDMI Input Supported Video Resolution.	1080p, 1080i, 720p, 576i, 480p, and 480i
Power Consumption	Operating 36W; Standby 0.8W
Power Input Connect Included Adapter	DC 12V, 4A
Included Adapter Connect DC input of unit	Input AC100-240V, 50/60Hz Output DC12V, 4A
Signal Port	Vi deo / V GA / H DM I
USB Port	Support USB device up to 1TB Support format mpeg1, Mpeg2, mpeg4, mp3, Jpeg
MicroSD Card	Support MicroSD card up to 32GB Support format mpeg1, Mpeg2, mpeg4, mp3, Jpeg

Weight and Dimensions

Weight	0.9 kg
Dimensions	203 x 150 x 82 mm